Modern Drilling Practice a Treatise On the Use of Various Type of Single And M
Modern Drilling Practice a Treatise On the Use of Various Type of Single And M
Edward K Hammond
The book Modern Drilling Practice a Treatise On the Use of Various Type of Single And M was written by author Edward K Hammond Here you can read free online of Modern Drilling Practice a Treatise On the Use of Various Type of Single And M book, rate and share your impressions in comments. If you don't know what to write, just answer the question: Why is Modern Drilling Practice a Treatise On the Use of Various Type of Single And M a good or bad book?
What reading level is Modern Drilling Practice a Treatise On the Use of Various Type of Single And M book?
To quickly assess the difficulty of the text, read a short excerpt:
The chuck shown at A, in Fig. 5, is made by the Jacobs Mfg. Co. , and tightening of the jaws is accomplished in the following manner : A hand wrench carry- WacMnery Fig. 6. Another Chuck of the Geared Type ing pinion a is piloted to fit into bushings in the chuck body, and this pinion a meshes with gear teeth b cut in the bottom of a sleeve of which threaded ring c is an integral part. This threaded ring meshes with threads cut in the upper outside portion of each of the three chuck jaws d. Evi...dently, when the wrench is turned, pinion a turns sleeve b and threaded ring c, which is an integral part of the sleeve, thus either pushing down or lifting chuck jaws d according to the direction in which the wrench is turned. By having jaws d inclined to the axis of the drill, raising or lowering the jaws causes them to release their grip on the drill shank or to secure a firm grip. 122 MODERN DRILLING PRACTICE At B, Fig. 5, there is shown a chuck operating on the same general principle, which is made by the J.
User Reviews: